High Quality New Tool HW-BIP Tester
Operation instructions
1) Install the tested injector to the special oil collector;
2) Connect BIP sensor plug;

3) Connect Unidirectional valve, please pay attention to the direction;
4) Connect the injector drive signal harness;

Not connected to the test bench housing;
(The ground wire of the tester can also be connected with the negative pole of the switching power supply supplied by the main control system of the test bench);
6) Plug in the power of the BIP tester.;
7) Start the test bench. When the pressure is stable, the response time will be displayed on the BIP tester screen.;
8) The lower left corner of the BIP tester displays the frequency of the fuel injector tested, and the response time is displayed in the upper right corner;
9) to ensure that the response time test is more accurate,
The pulse width of the injector is set to be greater than 500us, the common rail pressure is greater than 80Mpa, and the frequency is less than 40Hz.
Send Inquiry to This Supplier
You May Also Like
-
New Energy DetectorUS$ 1MOQ: 1 Box
-
TU-443 Multiple-function Oil Combustion Pressure Meter & Fuel Injection Pressure TesterNegotiableMOQ: 1
-
Common Rail ValveUS$ 1 - 800MOQ: 1 Piece
-
Delivery ValveNegotiableMOQ: 6 Pieces
-
DIG01013 2016 New Car ToolUS$ 5.8 - 6.8MOQ: 5 Pieces
-
Automobile Engine ScannerUS$ 700 - 1,000MOQ: 10 Pieces
-
Mechanics Stethoscope Diagnostic Tool Cosy SpecializedUS$ 4.79 - 5.43MOQ: 1 Piece
-
Electronic Measuring InstrumentNegotiableMOQ: 1 Set
-
Cylinder LeakDown TesterNegotiableMOQ: 1
-
HXT16 CAR REPARE TOOLSUS$ 0.1 - 1.5MOQ: 5000 Sets


